Tell us about
your project.

Rubber batch off cooling line application and required finished result; Sheet and anti-tack: Specify strip width, thickness, heat content and anti-tack chemistry. Application and drainage must prevent sticking without leaving unacceptable contamination for later processing.; Cooling and storage: Compare hanging, supported transport, airflow and stacking. Cooling residence and folding must suit the compound and the handling method used after discharge.; Representative input variation and difficult operating conditions; Application risks and exclusions: Cool surface appearance does not establish a safe stack condition; internal heat and pressure can cause blocking or deformation during storage.; Site and supporting services: Coordinate mill discharge, cooling air, anti-tack preparation, drainage and stack handling with safe access to elevated sections.; Acceptance method and retained evidence: Run representative hot compound, check cooling uniformity, residual moisture and anti-tack coverage and inspect stored stacks for blocking and deformation.; Maintenance and support scope: Service conveyors, hangers, fans, baths and stacking tools; document cleaning and compound changeover procedures.; OEM/ODM changes requested: Cooling paths, anti-tack modules, stacking and controls may be engineered; changed compound duties require trials.; Destination, local installation conditions and documentation language; Drawings, samples, tooling ownership and revision control; Operating sequence, changeovers, training and commissioning responsibilities.