Tell us about
your project.

Finger jointing line application and required process result; Timber grading and joint profile: Define species, moisture, section range and intended structural or nonstructural use. Defects near the joint and end-squareness affect the usable material and required rejection strategy.; Adhesive and pressing sequence: Specify adhesive approval, open time, application method and curing arrangement. Milling, glue application and end pressure must remain coordinated during starts, stops and changes of timber section.; Representative input variation and difficult production cases; Required acceptance evidence: Evaluate joint geometry and glue distribution, then perform the agreed strength tests after the specified cure. Record moisture and adhesive conditions alongside good-joint output and trim waste.; Site and utility scope: Provide conditioned timber storage, extraction at end milling, adhesive handling and supported curing space. Ensure rejection pieces can be removed without mixing them into accepted structural material.; Service provision: Track cutter condition, glue metering, press alignment and cleanup procedures. Keep batch traceability between timber, adhesive, joint settings and recorded test results.; OEM/ODM engineering scope: OEM feeding and sorting are configurable; ODM joint profiles require adhesive-system validation and the relevant structural timber certification before any strength claim is made.; Upstream preparation and downstream handling interfaces; Destination country and applicable installation requirements; Production schedule, changeover mix and operator availability; Drawings, samples, inspection method and rejected-output criteria.