Tell us about
your project.

Industrial desiccant dehumidifier application and required process result; Humidity and moisture load: State target humidity or dew point, process-air temperature, outdoor conditions, leakage, occupancy and moisture released by products. Define the measurement point and operating schedule.; Regeneration and air circuit: Compare regeneration heat source, process and wet-air ducts, rotor seals, controls and filters. Check low-temperature duty and the heat added to the treated air.; Representative input variation and difficult production cases; Required acceptance evidence: Demonstrate the agreed humidity at documented airflows, inlet conditions and regeneration settings. Record startup pull-down and performance under a representative moisture load.; Site and utility scope: Prepare ducts, regeneration services, wet-air discharge, power, access and insulation where condensation could occur.; Service provision: Inspect rotor condition, seals, filters, drives and humidity sensors. Track regeneration temperatures and airflow to diagnose reduced moisture removal.; OEM/ODM engineering scope: OEM ducts and controls can be configured; ODM unusual contaminants or very low dew points require material compatibility and performance validation.; Upstream preparation and downstream handling interfaces; Destination country and applicable installation requirements; Production schedule, changeover mix and operator availability; Drawings, samples, inspection method and rejected-output criteria.